MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
b. Turn the SST upside down, and set it on the booster.
SST 09737-00011
c. Measure the clearance between the booster push rod and pin head (SST).
Clearance: 0 mm (0 inch)
d. Using SST, adjust the booster push rod length until the push rod lightly touches the pin head.
SST 09737-00020
3. CONNECT VACUUM HOSE TO BRAKE BOOSTER
4. INSTALL BRAKE LINES
Using SST, install the 2 brake lines to the ABS actuator.
Torque:
15 Nm (155 kgf-cm, 11 ft. lbs.)
14 Nm (143 kgf-cm, 10 ft. lbs.) for use with SST
HINT: Use a torque wrench with a fulcrum length of 30 cm (11.81 inch).
5. INSTALL MASTER CYLINDER
6. FILL RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM
7. CHECK FOR FLUID LEAKAGE
8. CHECK AND ADJUST BRAKE PEDAL
9. DO OPERATIONAL CHECK
10. INSTALL TOOL BOX
11. INSTALL LUGGAGE COMPARTMENT TRIM BOX COVER