MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
a. Disconnect the 2 electric cooling fan connectors.
b. Remove the 2 bolts, 2 nuts and 2 spear wheel carrier extensions.
c. Remove the 2 bolts and electric cooling fan.
DISASSEMBLY
1. REMOVE FANS
Remove the nut and fan.
2. REMOVE FAN MOTORS
a. Disconnect the wire and connector holder from the fan shroud.
b. Remove the 3 screws and fan motor.
REASSEMBLY
1. INSTALL FAN MOTORS
a. Install the fan motor with the 3 screws.
Torque: 2.55 Nm (26 kgf-cm, 23 inch lbs.)
b. Install the wire and connector holder to the fan shroud.
2. INSTALL FANS
Install the fan with the nut.
Torque: 6.18 Nm (63 kgf-cm, 55 inch lbs.)
INSTALLATION