toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

All Technical Service Bulletins for Engine Control Module: > < Initial Inspection and Diagnostic Overview|Page 2060
Page 1
background image

Engine Control Module: Customer Interest
Engine Controls - MIL ON/DTC P0300 Set

ENGINE
EG005-03

April 11, 2003

Title:
M.I.L. "ON" DTC P0300

Models
'00 - '03 MR2 Spyder

Introduction 
Some MR2 Spyder vehicles may exhibit a M.I.L. "ON" condition with Diagnostic Trouble Code P0300 stored in the Engine Control Module or ECM
(SAE term: Powertrain Control Module/PCM). In some of these cases, standard misfire repair methods may not uncover any identifiable sources of
misfire. An updated ECM (PCM) has been made available to prevent repeat occurrences of this M.I.L. "ON" condition.

Applicable Vehicles 
^

2000 - 2003 model year MR2 Spyder vehicles produced BEFORE the Production Change Effective VINs shown below.

Production Change Information

Parts Information

Repair In the event that no problem can be identified following the diagnostic procedures for Procedure DTC P0300, the ECM (PCM) must be replaced.

ECM (PCM) location and replacement information can be found on TIS (Technical Information System) under the SF1 Section and ECM Subsection for
the appropriate model year MR2 Spyder.

Warranty Information

Applicable Warranty*:

This repair is covered under the Toyota Federal Emissions Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first,
from the vehicle's in-service date.

* Warranty application is limited to correction of a problem based upon a customer's specific complaint.

All Technical Service Bulletins for Engine Control Module: > < Initial Inspection and Diagnostic Overview|Page 2060