MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
/Page-638003.png)
a. Disconnect the throttle position sensor connector.
b. Disconnect the throttle control motor connector.
c. Disconnect the PCV hose from the throttle body.
d. Disconnect the 2 water bypass hoses from the throttle body.
e. Remove the 2 bolts and throttle body bracket.
f.
Remove the 2 bolts, 2 nuts, throttle body and 2 gaskets from the intake manifold.
g. Disconnect the accelerator position sensor connector.
INSTALLATION
1. INSTALL THROTTLE BODY
a. Install 2 new gaskets to the intake manifold as shown in the illustration.