MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
REMOVE AIRBAG SENSOR ASSEMBLY
a. Take out the floor carpet.
b. Disconnect the wire clamp.
c. Disconnect the airbag sensor connectors.
NOTE: Disconnect the connectors with the airbag sensor assembly installed.
d. Using a torx wrench, remove the 3 screws and airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
INSTALLATION
NOTE:
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new ones. Never reuse the airbag sensor assembly involved in
a collision with the airbag has deployed.
-
Never repair a sensor in order to reuse it.
INSTALL AIRBAG SENSOR ASSEMBLY