MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
a. Place the generator washer on the rotor.
b. Using a 29 mm socket wrench and press, slowly press in the rectifier end frame.
c. Install the wire clip and 4 nuts.
Torque:
Nut A: 4.5 N.m (46 kgf.cm, 40 in.lbf)
Nut B: 5.4 N.m (55 kgf.cm, 48 in.lbf)
3. INSTALL PULLEY
a. Install the pulley to the rotor shaft by tightening the pulley nut by hand.
b. Hold SST (A) with a torque wrench, and tighten SST (B) clockwise to the specified torque.
SST 09820-63010