Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
(c)
Check only the valves indicated as shown. Measure the valve clearance. (See procedure in step (a))
6. Adjust valve clearance.
(a)
Remove the adjusting shim.
^
Turn the crankshaft to position the cam lobe of the camshaft on the adjusting valve points upward.
^
Position the notch of the valve lifter so that the shim can be removed with a small screwdriver as shown in the illustration.
^
Using Special Service Tool (SST) (A), press down the valve lifter and place SST (B) between the camshaft and valve lifter flange.
Remove SST (A).
SST 09248 - 55040 (Set), (09248 - 05410, 09248 - 05420) or equivalent.
NOTE: Apply SST (B) at slight angle on the side marked with "9", at the position shown in the illustration.
NOTE: Set SST (A) at position A, if position A is too narrow, at position B. as shown in the illustration.