Pickup 2WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1989)
Pick-Up Coil: Testing and Inspection
***UPDATED BY TSB# EN91-007, JUNE 1991
Pick-up Coil Connector
1.
Disconnect the wiring connector near the distributor.
2.
Connect one end of an ohmmeter to the G1 terminal. Connect the other end to the G- terminal.
G1 Pickup Coil Resistance:
130 - 210 ohms
3.
Connect one end of an ohmmeter to the G2 terminal. Connect the other end to the G- terminal.
G2 Pickup Coil Resistance:
130 - 210 ohms
4.
Connect one end of an ohmmeter to the NE terminal. Connect the other end to the G- terminal.
NE Pickup Coil Resistance:
130 - 210 ohms
Pick-up Coil Air Gap
5.
Using a non-magnetic feeler gauge, measure the gap between the signal rotor and pickup coil projection.
G1 Air Gap:
0.008 - 0.016 in (0.2 - 0.4 mm)
G2 Air Gap:
0.008 - 0.016 in (0.2 - 0.4 mm)
NE Air Gap:
0.008 - 0.016 in (0.2 - 0.4 mm)
NOTE: The air gap is not adjustable. If any of the above tests reveal a pick-up coil outside specifications, replace the distributor assembly.