Pickup 2WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1989)
2. ADJUST CLUTCH START SWITCH
(a) Measure the pedal stroke, and check the switch clearance "A" using the chart left.
(b) Loosen and adjust the switch position.
(c) Recheck that the engine does not start when the clutch pedal is released.
INSPECTION OF CLUTCH START CANCEL SWITCH
1. INSPECT CONTINUITY OF CLUTCH START CANCEL SWITCH
(a) Check that there is no continuity when connect the positive (+) lead from the ohmmeter to terminal 2 and the negative (-) lead to terminal 1.
(b) Check that there is no continuity when connect the positive (+) lead from the ohmmeter to terminal 3 and the negative (-) lead to terminal 1.
(c) Check that there is no continuity between terminals 2 and 3.
If continuity is not as specified, replace the clutch start cancel switch.
2. INSPECT OPERATION OF CLUTCH START CANCEL SWITCH
(a) Connect positive (+) lead from the battery to terminal 3 and connect negative (-) lead to terminal 1.
(b) Check that there is no continuity when connect the positive (+) lead from the ohmmeter to terminal 2 and the negative (-) lead to terminal 1.