Pickup 4WD L4-2366cc 2.4L SOHC (22R) (1984)
Brake Drum: Service and Repair
Type 2 (Leading-Trailing Type)
Removal
1.
Raise and support rear of vehicle, then remove wheel and tire assembly.
2.
Remove brake drum. If brake drum cannot be remove easily, insert a suitable screwdriver through hole in backing plate, then push adjuster lever
away from adjuster and back of adjustment tension.
Fig. 6 Exploded View Of Brake Assembly (2WD Leading/Trailing)
3.
Remove return spring adjuster, using a suitable tool, then the front shoe hold-down spring and pin, Fig. 9.
4.
Remove front brake shoe, then the anchor spring.
5.
Remove hold-down spring and pin, then the rear shoe, using a suitable tool.
6.
Remove strut and spring from parking brake lever, then the adjusting lever spring.
7.
Remove parking brake cable from parking brake lever.
Fig. 3 Measuring Brake Drum Inside Diameter
Inspection
1.
Measure brake drum inside diameter. Inside diameter should be 10.00 inches, Fig. 6.