Pickup 4WD L4-2366cc 2.4L SOHC (22R) (1984)
/Page-549002.png)
Fig. 7 Measuring brake shoe lining thickness
2.
Measure brake shoe lining thickness, Fig. 7. Minimum thickness should be .04 inch.
3.
Inspect brake lining and drum for proper contact and replace drum or shoes as necessary.
4.
Inspect wheel cylinder for corrosion or damage.
5.
Inspect backing plate for wear or damage.
6.
Inspect bellcrank components for bending, wear or damage.
7.
Apply a suitable lubricant to backing plate contact areas.
Installation
1.
Apply a suitable lubricant to adjuster bolt threads and end.
Fig. 12 Exploded view of type 4 drum brake assembly. Pickup & 4Runner, 4 wheel drive
2.
Assemble adjuster to lever, then install adjuster lever spring, Fig. 12.
3.
Install No. 1 parking brake cable to parking brake lever shoe, then attach the other side of cable to No. 3 bellcrank.
4.
Position front shoe in place with end of shoe inserted into piston, then install shoe hold-down spring and pin using a suitable tool.
5.
Assemble anchor spring to front and rear shoe, then install rear shoe with end inserted in piston.
6.
Install rear shoe hold-down spring and pin, then the tension spring.
7.
If necessary, adjust bellcrank as follows:
