Pickup 4WD L4-2366cc 2.4L SOHC (22R) (1984)
/Page-293001.png)
Oxygen Sensor: Testing and Inspection
EFI Engine
Fig.39 Checking Oxygen Sensor with Voltmeter
1.
Connect voltmeter to EFI service connector using adapter 09842-14010 or equivalent, Fig. 39. Connector is located in harness with ``Check
Engine'' connector.
2.
Connect suitable tachometer, start engine and run until it reaches normal operating temperature.
3.
Run engine at 2500 RPM for approximately 2 minutes to heat oxygen sensor.
4.
With engine running at 2500 RPM, voltmeter needle should deflect at least 8 times every 10 seconds.
