Pickup 4WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1990)
1. REMOVE VALVE BRACKET
(a) Remove the nut and bolt as shown.
(b) Remove the two nuts, and remove the bracket and set plate from the valve body.
2. DISCONNECT SPRING FROM VALVE
Using pliers, remove the clip, and remove the spring from the valve.
3. REMOVE SHACKLE NO.1 AND NO.2
Remove the nut and bolt, and then remove the shackle No.1 and No.2, and two plate washers from the load sensing spring assembly.
4. DISASSEMBLE LOAD SENSING SPRING
Disassemble the following parts.
(a) Bushings
(b) Collars
(c) Rubber plates
(d) Load sensing valve boot
(e) Load sensing spring boot
INSPECTION OF LSP & BV OR LSPV