Axle Shaft Assembly Maintenance - Constant Velocity Type (Page 2411)
(a) Attach SST to the backing plate. SST 09521-25011
(b) Using a press, press the rear axle shaft from the backing plate.
NOTICE: When pulling out the rear axle, be careful not to damage the oil seal.
REAR AXLE SHAFT COMPONENTS INSPECTION AND REPAIR
1. INSPECT AXLE SHAFT AND FLANGE FOR RUNOUT FOR WEAR, DAMAGE OR RUNOUT
Maximum shaft runout: 2.0 mm (0.079 in.)
Maximum flange runout: 0.2 mm (0.008 in.)
If the rear axle shaft or flange are damaged or worn, or if runout is greater than maximum, replace the rear axle shaft.
2. INSPECT OUTER OIL SEAL
(a) Check for damage.
(b) Check the oil seal lip for wear or damage. If necessary, replace the oil seal.
3. REMOVE OUTER OIL SEAL
-
Using SST, remove the oil seal.
SST 09308-00010
4. INSPECT REAR AXLE BEARING
-
Check for wear or damage.
-
If necessary, replace the rear axle bearing.
5. REPLACE REAR AXLE BEARING
(a) Using SST and a press, out the bearing.
SST 09223-56010,09608-35014 (09608-06100)