Previa Van 2WD L4-148.8 2438cc 2.4L DOHC (2TZ-FE) (1992)
/Page-313009.png)
(e) Install and torque the 3 bolts.
Torque: 18 N.m (185 kgf.cm, 13 ft.lbf)
7. INSTALL OIL FILTER BRACKET WITH OIL FILTER
(a) Place a new 0-ring into the groove of the timing chain case.
(b) Install the oil filter bracket with the 3 bolts.
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
8. INSTALL BAFFLE PLATE AND NO.2 OIL DIPSTICK GUIDE
(a) Install the baffle plate with the 3 nuts.
Torque: 5 N.m (50 kgf.cm, 43 in.lbf)
(b) Install the No.2 oil dipstick guide with the 2 bolts.
Torque: 18 N.m (185 kgf.cm, 13 ft.lbf)
9. INSTALL CRANKCASE
(a) Remove any old packing material and be careful not to drop any oil on the contacting surfaces of the crankcase and cylinder block.
^ Using a razor blade an gasket scraper, remove all the packing (FIPG) material from the gasket surfaces.
^ Thoroughly clean all components to remove all the loose material.
^ Clean both sealing surfaces with a non-residue solvent.
NOTICE: Do not use a solvent which will affect the painted surfaces.
(b) Apply seal packing to the joint part of the cylinde block and timing chain case, cylinder block and rear oil seal retainer.
Seal packing: Part No.08826-00080 or equivalent
