Previa Van 2WD L4-148.8 2438cc 2.4L DOHC (2TZ-FE) (1992)
Receiver Dryer: Service and Repair
RECEIVER REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
INSTALLATION HINT: Evacuate air from refrigeration system. Charge system with refrigerant and inspect for leakage of refrigerant.
Specified amount:
w/o Rear A/C
950 ± 50 g (33.51 ± 1.76 oz.)
w/ Rear A/C
1,200 ± 50 g (42.32 ± 1.76 oz.)
2. DISCONNECT 2 LIQUID TUBES FROM RECEIVER
Torque: 13.0 Nm (135 kgf.cm, 10 ft. lb.)
REMOVAL NOTE: Cap the open fittings immediately to keep moisture or dirt out of the system.
INSTALLATION HINT: Lubricate 2 new O-rings with compressor oil and install the tubes.
3. REMOVE RECEIVER FROM RECEIVER HOLDER
a. Remove the 2 holder bolts and pull out the receiver.
b. Remove the 2 bolts and holder.
INSTALLATION HINT: If receiver was replaced, add compressor oil to compressor.
Add 20 cc (0.7 fl.oz.)
Compressor oil:
ND-OIL 8 or equivalent
RECEIVER INSTALLATION
Installation is in the reverse order of removal.