Previa Van 2WD L4-148.8 2438cc 2.4L DOHC (2TZ-FE) (1992)
REMOVE AND INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Using a torx wrench, loosen and tighten the 3 screws.Torx wrench: T40
(b) Disconnect and connect the connector.
NOTICE: Removal and installation of the connector is done with the sensor assembly installed.
(c) Using a torx wrench. tighten the 3 screws. Torx wrench: T40
Torque: 15 Nm (150 kgf^cm, 11 ft.lb).
NOTICE:
^
Make sure the sensor assembly is installed to the specified torque.
^
If the sensor assembly has been dropped. or there are cracks. dents or other defects in the case. bracket or connector. replace the sensor
assembly with a new one.
^
When installing the sensor assembly. take care that the airbag wiring does not interfere with other parts and is not pinched between other parts.
^
After Installation. shake the sensor assembly to check that there is no looseness.
WIRE HARNESS AND CONNECTOR
HINT: The SRS wire harness is integrated with the cowl wire harness assembly and floor wire harness assembly.
The wires for the SRS wire harness are encased in a yellow corrugated tube and all the connectors in the system are a standard yellow color.
INSPECTION ITEMS