Previa Van 2WD L4-148.8 2438cc 2.4L DOHC (2TZ-FE) (1992)
/Page-875001.png)
Starter Motor: Service and Repair
Fig. 1 Starter Motor Installation
1.
Disarm airbag system, refer to MAINTENANCE PROCEDURES/AIRBAG ARMING & DISARMING.
2.
On 4WD models, remove front propeller shaft.
3.
On models equipped with manual transaxle, disconnect clutch slave cylinder and position aside. Do not disconnect clutch line.
4.
On all models, remove battery cable to starter attaching nut.
5.
Remove starter electrical connector.
6.
On 2WD models, remove starter attaching nuts and bolt, then remove.
7.
On 4WD models, remove center support bracket and starter attaching nuts and bolts, then remove.
8.
On all models, reverse to install. Torque A starter bolts as shown in Fig. 1, to 41 ft. lbs. and B starter bolts to 30 ft. lbs. On 4WD models, torque
center support bracket to stiffener plate to 43 ft. lbs. and bracket to starter to 12 ft. lbs.
9.
Rearm airbag system, refer to MAINTENANCE PROCEDURES/AIRBAG ARMING & DISARMING.