Previa Van 2WD L4-148.8 2438cc 2.4L DOHC (2TZ-FE) (1992)
Wiper Switch: Service and Repair
Service
Headlight Dimmer, Turn Signal & Wiper/Washer Switch
Fig. 3 Combination Switch Service
1.
Remove combination switch as outlined under REMOVAL/INSTALLATION.
2.
Using suitable small screwdriver, disengage headlight dimmer and turn signal switch wiring from combination switch connector. Note position of
wires.
3.
Remove switch to switch body attaching screws, Fig. 3.
4.
Reverse to install, noting the following:
a. Ensure smooth switch operation in all positions.
b. Install electrical terminals to combination switch in same position as they were removed.
Headlamp Switch
Fig. 3 Combination Switch Service
1.
Remove combination switch as outlined under REMOVAL/INSTALLATION.
2.
Using suitable small screwdriver, disengage headlight dimmer and turn signal switch wiring from combination switch connector. Note position of
wires.
3.
Remove headlamp switch attaching screws, Fig. 3, then remove switch, then ball and spring assembly.
4.
Reverse to install, noting the following:
a. Ensure smooth switch operation in all positions.