Previa Van 4WD L4-148.8 2438cc 2.4L DOHC (2TZ-FE) (1991)
/Page-1063001.png)
Control Assembly: Service and Repair
CONTROL ASSEMBLY
1. REMOVE CLUSTER FINISH CENTER UPPER PANEL.
a. Push up the release lock at the center on the lower side of the panel.
b. Remove the panel by pulling.
2. REMOVE CLUSTER FINISH CENTER PANEL WITH RADIO.
a. Remove two screws and two bolts.
b. Pull the panel with the radio rearward and remove it, then disconnect the connectors.
3. REMOVE HEATER CONTROL.
a. Remove four screws and hang the heater control.
4. REVERSE PROCEDURE TO REINSTALL.