Previa Van DX 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
(a) Paint matchmarks on the rear flexible coupling, flange and crankshaft pulley.
CAUTION: Do not place matchmarks using a punch, etc.
(b) Install a service bolt and a nut to the front end of equipment drive shaft.
(c) Disconnect the equipment drive housing from the ground strap.
(d) Rotate the equipment drive shaft by turning the service nut to a position where the bolts are easy to remove, then remove the 3 bolts (A) and 3
washers.
CAUTION: Do not remove the other 3 bolts (B).
(e) Remove the 3 bolts holding the equipment drive shaft and equipment drive housing.