Previa Van DX 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
If toe-in is not within specification adjust by the tie rod end.
5. Adjust camber.
NOTICE: After the camber has been adjusted, inspect the toe-in.
a. Remove the front wheels.
b. Remove the 2 nuts on the lower side of the shock absorber.
c. Coat the threads of the nuts with engine oil.
d. Temporarily install the 2 nuts.
Fig. 1 Camber Adjustment.
e. Adjust the camber by pushing or pulling the lower side of the shock absorber in the direction in which the camber adjustment is required.
f.
Tighten the nuts.
Torque:
Set bolt: 314 Nm (232 ft. lbs.)
Adjust bolt: 221 Nm (163 ft. lbs.)
g. Install the front wheels.
Torque: 103 Nm (76 ft. lbs.)
h. Check the camber.
HINT:
^
Try to adjust the camber to the center value.
^
Adjusting value for the set bolts is 6' - 30' (0.1° - 0.5°).