Previa Van DX 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
k. If not within specification, adjust by either increasing or decreasing the number of washers on both sides by an equal amount.
HINT: There should be no clearance between the plate washer and case.
Make sure that there is ring gear backlash.
11. Adjust side bearing preload.
a. Remove the ring gear teeth side plate washer and using a micrometer, measure the thickness.
b. Using the backlash as a reference, install a new washer of 0.06 - 0.09 mm (0.0024 - 0.0035 inch) thicker than the washer removed.
HINT: Select a washer which can be pressed in 2/3 of the way with your finger.
c. Using SST # 09504 - 22011 or equivalent and hammer, install the plate washer.
d. Recheck the ring gear backlash.
Backlash: 0.13 - 0.18 mm (0.0051 - 0.0071 inch)
