Previa Van DX 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
B.
From the flexible coupling side, install the new bolts and washers, then tighten the 3 new nuts from the propeller shaft side.
Torque: 33 Nm (340 kgf cm, 25 ft lbs)
NOTE:
^
Bolts, nuts and washers are not reusable.
^
Insert the bolts on the flexible coupling side, and tighten the nuts on the propeller shaft tube side.
^
Do not deform the rubber bushing of the flexible coupling by twisting.
C.
Use the other half of the grease provided in the kit on the tip of the centering pin of the bearing assembly.
D.
Insert the centering pin of the bearing into the propeller shaft noting the alignment marks on the propeller shaft tube and the coupling flange.