toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Cool Box|Page 5623 > < Cool Box|Page 5621
Page 3
background image

(a) Remove the nine screws from the lower case. 
(b) Separate the upper and the lower cases.

HINT:  Empty the drain before removing the lower case.

3. REMOVE RIGHT AND LEFT BLOWER MOTOR ASSEMBLIES

(a) Remove the three screws and disconnect the connector.
(b) Disengage the eight pawls and remove the blower motor assembly.

4. REMOVE BLOWER RESISTOR

Disconnect the connector, then remove the two screws end the blower resister.

HINT:  The register can be removed after the right suction grill is removed.

5. REMOVE REAR BLOWER SWITCH

Disconnect the connector, then remove the two screws ad the rear A/C switch.

6. REMOVE EVAPORATOR ASSEMBLY

Remove the evaporator assembly by pulling it out.

7. DISASSEMBLE BLOWER MOTOR ASSEMBLY

(a) Disengage the eight pawls of the blower case and separate the blower motor assembly into an upper and a lower piece.

Cool Box|Page 5623 > < Cool Box|Page 5621