Previa Van LE 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
Neutral Safety Switch: Service and Repair
PARK/NEUTRAL POSITION SWITCH REPLACEMENT
1. Disconnect oil cooler pipes.
a. Remove the bolt and disconnect the oil pipe clamp.
b. Disconnect ATF temperature sensor connector.
Remove cooler pipes.
Torque: 34 N.m (25 ft. lbs.)
2. Remove park/neutral position switch.
a. Disconnect the connector.
b. Pry off the lock washer and remove the nut.
c. Remove the bolt and park/neutral position switch.
3. Install park/neutral position switch.
a. Install the park/neutral position switch and bolt.
Torque: 13 N.m (9 ft. lbs.)
b. Install a new lock plate and the nut.
Torque: 3.9 N.m (35 inch lbs.)
c. Stake the nut with the lock plate.
d. Adjust the park/neutral position switch.
1. Loosen the park/neutral position switch bolt and set the shift lever to the N position.
2. Align the groove and neutral basic line.
3. Hold in position and tighten the bolt.
Torque: 13 N.m (9 ft. lbs.)
e. Connect the connector.
4. Connect oil cooler pipes.