Previa Van RWD L4-148.8 2438cc 2.4L DOHC SC (2TZ-FZE) (1996)
-
Check that the distributor rotor direction is as shown. If not, turn the equipment drive pulley one complete revolution.
8. Remove distributor.
-
Remove the 2 hold-down bolts.
-
Pull out the distributor from the cylinder head.
-
Remove the 0-ring.
INSTALLATION
1. Check No.1 cylinder to TDC/compression.
-
Turn the equipment drive pulley clockwise, and position the slit of the exhaust camshaft as shown.
-
Remove the service bolt and nut.
NOTE: If the service bolt and nut are not removed, the bolt head will hit and damage the cooling fan.
2. Install distributor.
-
Install a new 0-ring to the distributor.
HINT: Always use a new 0-ring when installing the distributor.