Previa Van RWD L4-148.8 2438cc 2.4L DOHC SC (2TZ-FZE) (1996)
Engine RPM Sensor (NE signal): Service and Repair
REMOVAL
1. Disconnect negative (-) terminal cable from battery.
CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal
cable is disconnected from the battery.
2. Disconnect crankshaft position sensor connector.
3. Remove crankshaft position sensor.
Remove the 2 bolts and crankshaft position sensor.
INSTALLATION
1. Install crankshaft position sensor.
-
Apply a light coat of engine oil on the 0-ring.
-
Install the crankshaft position sensor with the 2 bolts.
Torque: 8.5 Nm (74 in lb)
2. Connect crankshaft position sensor connector.
3. Connect negative (-) terminal cable to battery.