Previa Van RWD L4-148.8 2438cc 2.4L DOHC SC (2TZ-FZE) (1996)
Fuel Pressure Regulator: Testing and Inspection
1. Check that the battery voltage is above 11 volts.
2. Disconnect the negative (-) terminal of the battery.
CAUTION: Work must be started after 90 seconds from the time the ignition switch is turned to the LOCK position and the negative (-) terminal
cable is disconnected from the battery.
3. Remove the right hand engine service hole cover.
-
Remove the 3 screws and scuff plate.
-
Remove the bolt and disconnect the right hand seat belt from the front floor panel.
-
Remove the 4 bolts and right hand front seat.
-
Remove the 2 bolts and right hand front seat leg.
-
Remove the 2 bolts and jack holder.
-
Remove the 9 bolts and right hand engine service hole cover.