Prius L4-1.5L (1NZ-FXE) (Hybrid) (2003)
![background image](/toyota/prius/l4-1.5l_(1nz-fxe)_(hybrid)/Page-419004.png)
D.
Activate water pump by turning ignition switch to ON position. Allow pump to operate for 20 seconds, then turn the ignition switch to the
OFF position.
E.
Loosen the 2 bleeder plugs to bleed air.
F.
Close the 2 bleeder plugs again.
G.
Repeat steps D - F until the operation sound of the pump decreases and the coolant in the reservoir tank moves faster.
H.
With the ignition switch ON, wait for approximately 5 minutes.
I.
Adjust the coolant level inside the reservoir tank as shown in the illustration.
8.
After replacing the inverter assembly w/converter, clear DTC(s). Even if the master warning light is NOT lit, clear the DTC(s) using a Toyota
Diagnostic Tester.
If a Toyota Diagnostic Tester CANNOT be used, disconnect the auxiliary battery for 1 minute or more and connect it again.
9.
Verify operation of the inverter assembly w/converter after replacement.
Depressing the accelerator pedal to a degree of 50%, increase the speed up to approximately 9 mph (15 km/h) 3 or 4 times to check that there is
NO problem in the inverter operation.
10.
Test drive the vehicle to ensure that all repairs are satisfactory.