Prius L4-1.5L (1NZ-FXE) (Hybrid) (2003)
_(hybrid)/Page-444002.png)
2. DRAIN ENGINE COOLANT FROM RADIATOR
HINT: It is not necessary to drain out all the coolant.
3. REMOVE ELECTRIC COOLING FAN ASSEMBLY
4. REMOVE FRONT BUMPER
5. REMOVE RADIATOR RESERVOIR HOSE
6. DISCONNECT DISCHARGE AND LIQUID TUBE
a. Remove the 2 bolts and disconnect discharge and liquid tube.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
NOTICE: Cap open the fittings immediately to keep moisture or dirt out of the system.
HINT:
At the time of installation, please refer to the following item.
Lubricate 2 new O-rings with compressor oil and install them to the tubes.
b. Remove the bolt.
c. Disconnect the liquid tube and remove the bracket.
7. REMOVE RADIATOR UPPER SUPPORT
Remove the 2 bolts and 2 radiator upper supports.
8. REMOVE RADIATOR & CONDENSER MODULE
a. Push the radiator & condenser module toward engine.
b. Pull up the radiator until the lower radiator support is removed.
c. Pull it downward to remove it.
INSTALLATION
Installation is in the reverse order of removal.
On-Vehicle Cleaning
ON-VEHICLE CLEANING