RAV4 2-Door 4WD L4-2.0L (3S-FE) (1997)
![background image](/toyota/rav4_2-door_4wd/l4-2.0l_(3s-fe)/Page-700001.png)
Ignition Cable: Testing and Inspection
HIGH-TENSION CORDS INSPECTION
1. DISCONNECT HIGH-TENSION CORDS FROM SPARK PLUGS
Disconnect the high-tension cords at the rubber boot.
Do not pull on the high-tension cords.
NOTICE: Pulling on or bending the cords may damage the conductor inside.
2. DISCONNECT HIGH-TENSION CORD FROM IGNITION COIL
3. DISCONNECT HIGH-TENSION CORDS FROM DISTRIBUTOR CAP
4. INSPECT HIGH-TENSION CORD RESISTANCE
Using an ohmmeter, measure the resistance.
Maximum resistance: 25 k Ohms per cord
If the resistance is greater than maximum, check the terminals.
If necessary, replace the high-tension cord.
5. RECONNECT HIGH-TENSION CORDS TO DISTRIBUTOR CAP
6. RECONNECT HIGH-TENSION CORD TO IGNITION COIL
7. RECONNECT HIGH-TENSION CORDS TO SPARK PLUGS