RAV4 2WD L4-2.5L (2AR-FE) (2009)
Keyless Entry Module: Service and Repair
Removal
DOOR LOCK: DOOR CONTROL RECEIVER: REMOVAL
REMOVAL
1. REMOVE REAR DOOR SCUFF PLATE RH
(a) Using a screwdriver, detach the 9 claws.
HINT: Tape the screwdriver tip before use.
(b) Using a clip remover, detach the 2 clips and remove the garnish.
2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
3. REMOVE REAR FLOOR NO. 1 BOARD (w/o Rear No. 2 Seat)
4. REMOVE DECK BOARD ASSEMBLY (w/o Rear No. 2 Seat)
5. REMOVE NO. 2 SEAT HINGE COVER LH (w/ Rear No. 2 Seat) See: Body and Frame/Seats/Service and Repair/Rear No. 2 Seat
Assembly/Removal
6. REMOVE NO. 2 SEAT HINGE COVER RH (w/ Rear No. 2 Seat)
HINT: Use the same procedures described for the LH side.
7. REMOVE NO. 2 SEAT LEG COVER LH (w/ Rear No. 2 Seat) See: Body and Frame/Seats/Service and Repair/Rear No. 2 Seat
Assembly/Removal
8. REMOVE NO. 2 SEAT LEG COVER RH (w/ Rear No. 2 Seat)
HINT: Use the same procedures described for the LH side.
9. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (w/ Rear No. 2 Seat) See: Body and Frame/Seats/Service and Repair/Rear No. 2 Seat
Assembly/Removal
10. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)
11. REMOVE REAR FLOOR NO. 3 BOARD
12. REMOVE REAR FLOOR NO. 2 BOARD
13. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
14. REMOVE REAR FLOOR FINISH PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
15. REMOVE REAR DECK TRIM COVER RH (w/ Rear No. 2 Seat)
(a) Remove the bolt.
(b) Using a screwdriver, detach the 4 claws and remove the trim cover.
HINT: Tape the screwdriver tip before use.
16. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL RH (w/o Rear No. 2 Seat) See: Body and Frame/Seats/Service and Repair/Rear
No. 1 Seat Assembly (for RH Side)/Removal