RAV4 2WD L4-2.5L (2AR-FE) (2009)
Navigation System: Reading and Clearing Diagnostic Trouble Codes
NAVIGATION: NAVIGATION SYSTEM: DTC CHECK / CLEAR
DTC CHECK / CLEAR
HINT:
-
Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be
shown exactly the same as on the actual vehicle.
-
After the ignition switch is turned to ON, check that the map is displayed before starting the diagnostic mode. Otherwise, some items
cannot be checked.
1. START DIAGNOSTIC MODE
(a) There are 2 methods to start diagnostic mode. Start the mode by using one of them.
(b) Method 1
(1) Start the engine.
(2) While pressing and holding the "INFO" switch, operate the light control switch: OFF -> Turn ON -> Turn OFF -> Turn ON -> Turn OFF
-> Turn ON -> Turn OFF.
(3) The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result
will be displayed.
(c) Method 2
(1) Start the engine.
(2) Press the "DISPLAY" switch.
(3) From the display quality adjustment screen, touch the corners of the screen in the following order: upper left -> lower left -> upper left ->
lower left -> upper left -> lower left.
(4) The diagnostic mode starts and the "System Check Mode" screen will be displayed. Service inspection starts automatically and the result
will be displayed.
2. FINISH DIAGNOSTIC MODE