RAV4 2WD L4-2.5L (2AR-FE) (2009)
Spoiler: Service and Repair
Installation
EXTERIOR: REAR SPOILER: INSTALLATION
INSTALLATION
HINT: When installing the spoiler, heat the vehicle body and spoiler using a heat light.
Standard heating temperature:
NOTE: Do not heat the body and spoiler excessively.
1. INSTALL CENTER STOP LIGHT
(a) Install the center stop light with the 2 screws.
2. INSTALL REAR SPOILER
(a) Clean the vehicle body surface.
(1) Using a heat light, heat the vehicle body surface.
(b) If reusing the spoiler:
Clean the spoiler.
(1) Using a heat light, heat the spoiler.
(c) Connect the center stop light connector.
(d) Install the spoiler with 3 clips.
(e) Install the 3 bolts.
Torque: 7.5 Nm (76 kgf-cm, 66 in-lbf)
3. INSTALL BACK DOOR CENTER GARNISH See: Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Reassembly
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL