RAV4 2WD L4-2.5L (2AR-FE) (2009)
(3) Insert the sensor clip (labeled F) into the hole on the absorber lower bracket.
(c) Install the sensor clamp and sensor clip as follows.
(1) Set the sensor clamp (labeled G) on the side member, and then install the bolt (labeled H).
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE: Do not twist the sensor wire when installing the clamp.
(2) Insert the sensor clip (labeled I) into the hole on the apron.
(d) Connect the sensor connector.