RAV4 2WD L4-2.5L (2AR-FE) (2009)
Radiator Cooling Fan Motor Relay: Testing and Inspection
2AR-FE COOLING: COOLING FAN RELAY: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
2. REMOVE ENGINE ROOM NO. 2 RELAY BLOCK COVER
3. INSPECT NO. 1 COOLING FAN RELAY (FAN NO. 1)
(a) Remove the relay from the engine room No. 2 relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the No. 1 cooling fan relay.
(c) Install the relay.
4. INSPECT NO. 2 COOLING FAN RELAY (FAN NO. 2)
(a) Remove the relay from the engine room No. 2 relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
-
If the result is not as specified, replace the No. 2 cooling fan relay.
(c) Install the relay.