RAV4 2WD L4-2.5L (2AR-FE) (2009)
(d) Detach the 2 clamps.
(e) Remove the bolt and bracket.
(f) Apply battery voltage to the terminals of the connector to close the tumble control valves.
Standard:
NOTICE:
-
If this procedure is not performed, the valves may be damaged when the intake manifold is removed.
-
Apply battery voltage for 1 to 3 seconds.
-
If battery voltage is applied for more than 3 seconds, the actuator may be damaged.
-
Do not allow the lead wires to contact the other terminals.
(g) Remove the bolt.
(h) Detach the 2 clamps from the intake manifold and bracket.
(i) Disconnect the intake air control valve actuator connector.
(j) Detach the clamp and wire harness.
16. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)