RAV4 2WD L4-2.5L (2AR-FE) (2009)
Oil Pressure Sender: Service and Repair
Installation
2AR-FE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION
INSTALLATION
1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive:
TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent.
NOTE: Do not let adhesive adhere to the oil hole.
(b) Using a 24 mm deep socket wrench, install the oil pressure switch.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)
NOTE: Do not start the engine within 1 hour of installation.
(c) Connect the oil pressure switch connector.
2. INSPECT FOR OIL LEAK See: Engine Lubrication/Engine Oil/Service and Repair/Replacement