RAV4 2WD L4-2.5L (2AR-FE) (2009)
(a) Remove the attached vinyl tape from the pipe.
(b) Sufficiently apply compressor oil to new 2 O-rings and the fitting surface of the suction tube and liquid tube.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the 2 O-rings on the suction tube and liquid tube.
(d) Connect the suction tube and liquid tube.
HINT: After the connection, check that the claw of the piping clamp is engaged.
(e) Install the plate with the bolt.
Torque: 9.8 Nm (100 kgf-cm, 7 ft-lbf)
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
16. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.
17. REPLACE ENGINE COOLANT
(a) for 2GR-FE:
Refer to the following procedures See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair.
(b) for 2AR-FE:
Refer to the following procedures See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair.
18. CHARGE REFRIGERANT See: Service and Repair
19. WARM UP ENGINE See: Service and Repair
20. INSPECT FOR COOLANT LEAK
21. INSPECT FOR REFRIGERANT LEAK See: Service and Repair