RAV4 2WD L4-2.5L (2AR-FE) (2009)
/Page-2417001.png)
Brake Lamp Relay: Testing and Inspection
Stop Light Control Relay
LIGHTING: STOP LIGHT CONTROL RELAY: INSPECTION
INSPECTION
1. INSPECT STOP LIGHT CONTROL RELAY ASSEMBLY
(a) Disconnect the A43 stop light control relay connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
If the result is not as specified, repair or replace the wire harness or connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, repair or replace the wire harness or connector.
(d) Reconnect the A43 stop light control relay connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
