RAV4 2WD L4-2.5L (2AR-FE) (2009)
(b) Apply a small amount of engine oil to a new O-ring and install it to the oil filter cap.
(c) Set a new oil filter element into the oil filter cap.
(d) Remove any dirt or foreign matter from the installation surface of the engine.
(e) Apply a small amount of engine oil to the O-ring again and temporarily install the oil filter cap.
(f) Using SST, tighten the oil filter cap.
SST: 09228-06501
Torque: 25 Nm (255 kgf-cm, 18 ft-lbf)
NOTICE:
-
Make sure that the oil filter is installed securely as shown in the illustration.
-
Be careful that the O-ring does not get caught between any surrounding parts.
(g) Apply a small amount of engine oil to a new drain plug O-ring, and install it to the oil filter cap.
NOTE: Before installing the O-ring, remove any dirt or foreign matter from the installation surface of the oil filter cap.
(h) Install the oil filter drain plug.
Torque: 13 Nm (127 kgf-cm, 9 ft-lbf)
NOTE: Be careful that the O-ring does not get caught between any surrounding parts.
4. ADD ENGINE OIL
(a) Clean and install a new gasket and the oil pan drain plug.
Torque: 40 Nm (408 kgf-cm, 30 ft-lbf)
(b) Add new oil.
Standard Oil Grade: