RAV4 2WD L4-2.5L (2AR-FE) (2009)
(a) Remove the IG2 relay from the engine room No. 1 relay block.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Reinstall the relay.
NG -- REPLACE IG2 RELAY
OK -- Continue to next step.
8. CHECK HARNESS AND CONNECTOR (ECM - ENGINE ROOM NO. 1 RELAY BLOCK)
(a) Remove the IG2 relay from the engine room No. 1 relay block.
(b) Disconnect the ECM connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for open):
Standard Resistance (Check for short):