RAV4 2WD L4-2.5L (2AR-FE) (2009)
B -- Go to "Open in CAN Main Wire".
C -- Go to "Short in CAN Bus Lines".
A -- Continue to next step.
6. CHECK FOR SHORT TO GND IN CAN NO. 1 BUS (CANH, CANL - CG)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- Go to "Short to GND in CAN Bus Line".
OK -- Continue to next step.
7. CHECK FOR SHORT TO B+ IN CAN NO. 1 BUS (CANH, CANL - BAT)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- Go to "Short to B+ in CAN Bus Line".
OK -- Continue to next step.
8. CHECK ECUS CONNECTED TO CAN BUS USING TECHSTREAM*
(a) Connect the cable to the negative (-) battery terminal.
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
(b) Using Techstream, select "CAN Bus Check" from "System Select".
(c) Observe the screen for approximately 1 minute to check the ECUs and sensors displayed on the screen.
Result