RAV4 2WD L4-2.5L (2AR-FE) (2009)
(a) Disconnect the E70 No. 3 junction connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
OK -- REPAIR OR REPLACE CAN MAIN WIRE OR CONNECTOR (NO. 3 JUNCTION CONNECTOR - NO. 4 JUNCTION
CONNECTOR)
NG -- Continue to next step.
11. CONNECT CONNECTOR
(a) Reconnect the E70 No. 3 junction connector.
NEXT -- Continue to next step.
12. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (CENTER AIRBAG SENSOR)
(a) Disconnect the E45 center airbag sensor assembly connector.
(b) Measure the resistance of the DLC3.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO CENTER AIRBAG SENSOR ASSEMBLY (CANH,
CANL)
OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY
13. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (NO. 1 JUNCTION CONNECTOR - ECM)
(a) Disconnect the A36 No. 1 junction connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance: