RAV4 2WD L4-2.5L (2AR-FE) (2009)
Crankshaft Position Sensor: Service and Repair
Installation
2AR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
(a) Apply a light coat of engine oil to the O-ring of the sensor.
NOTE: Make sure that the O-ring is not cracked or jammed when installing the sensor.
(b) Apply adhesive to 2 or 3 threads of the bolt.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.
(c) Install the sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(d) Connect the sensor connector.
2. INSPECT FOR OIL LEAK
3. INSTALL REAR ENGINE UNDER COVER RH See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive
Belt/Service and Repair/Installation