RAV4 2WD L4-2.5L (2AR-FE) (2009)
Knock Sensor: Service and Repair
Installation
2AR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION
INSTALLATION
1. INSTALL KNOCK SENSOR
(a) Install the sensor with the bolt so that the sensor is angled as shown in the illustration.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
NOTE: The acceptable installation angle of the sensor is between 7° upward and 10° downward from the horizontal position.
(b) Connect the sensor connector.
2. INSTALL INTAKE MANIFOLD
(a) Install the intake manifold See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Installation.