RAV4 2WD L4-2.5L (2AR-FE) (2009)
Clockspring Assembly / Spiral Cable: Service and Repair
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE: INSTALLATION
INSTALLATION
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it See: Service Precautions.
1. INSTALL SPIRAL CABLE SUB-ASSEMBLY
(a) Check that the front wheels are facing straight ahead.
(b) Set the turn signal switch to the neutral position.
NOTE: Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.
(c) Install the spiral cable.
NOTE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.
(d) Connect the connectors to the spiral cable.
NOTE: When handling the airbag connector, do not damage the airbag wire harness.
(e) Attach the 4 clips to the column cover (upper).
(f) Install the steering column cover (upper).
2. INSTALL STEERING COLUMN COVER (LOWER)