RAV4 2WD L4-2.5L (2AR-FE) (2009)
10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(a) Remove the 2 bolts and anchor.
Installation
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION
INSTALLATION
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt -
Specified Torque For Standard Bolts.
1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(a) Align the adjuster positioning hole with the claw, and install the adjuster with the 2 bolts as shown in the illustration.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
2. INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH
(a) Install the plate as shown in the illustration.
HINT: Make sure the plate is firmly set into the garnish's claws.
3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
NOTE: Do not disassemble the retractor.