RAV4 2WD L4-2.5L (2AR-FE) (2009)
4. INSTALL SKID CONTROL SENSOR WIRE
NOTE: To prevent interference with other parts, do not twist the painted line areas of the sensor wire when installing it.
(a) Connect the skid control sensor wire connector (labeled A) to the skid control sensor.
(b) Install the sensor clamp (labeled B) with the bolt (labeled C).
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE: Do not twist the sensor wire when installing the clamp.
(c) Install the 2 sensor clamps (labeled D) with the 2 nuts (labeled E).
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)
NOTE: Do not twist the sensor wire when installing the clamps.
(d) Install the sensor clamp (labeled F) with the bolt (labeled G).
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE: Do not twist the sensor wire when installing the clamp.